Peugeot 308 Key Fob Replacement
Peugeot’s 308 might be a bit old but it’s still striking. It’s not the most luxurious car in its class, but it is a pleasant and peaceful drive.
Here at Coded Car Keys we are often asked to replace peugeot car key cover 308 key fobs. If the issue is persistent or intermittent, the following tips should assist.
Water Damage
If you accidentally drop your key fob into the puddle, or it gets wet while kayaking, canoeing or rafting or canyoning it is likely to be damaged by water. The best method to prevent this from happening is to keep it in a dry bag whenever you’re going outdoors or doing activities in which the fob may be exposed to excessive amounts of water.
It’s also crucial to ensure sure the fob has completely dried before you open it to use it again. If you detect any smells coming from the fob, like an industrial-like smell or a sour taste like windshield washer fluid, it’s another indication that it’s been submerged in water.
A wet circuit may cause the battery’s charge to drain or even explode. If you can remove your keyfob 308 out of the water and turn it upside up and shake as much water as you can prior to opening the casing. Once you have opened it, take off the battery and wipe down the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote entry keyless system may not function include a dead coin cell battery or receiver module issues signal interference or a defective chip. If none of the above are the issue you can restart the system by disconnecting the 12 voltage battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start technology that lets drivers start their vehicle from an extended distance, which allows them to warm up or cool down the car prior to entering. This feature is extremely helpful particularly during the cold winter months. However, there are times when the remote start system ceases operating due to a range of reasons, like a dead coin battery.
The coin-shaped battery contained inside the key fob can last between two and four years, based on how often it is used, the location it was purchased, and the way it is utilized. Its use-by date is typically written on the package or marked in the manual.
If the key fob stops working after being exposed water that is clean, remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob has been exposed to salty or soapy water, it may have fried the chip. It is recommended to replace it.
If you’re not sure the battery is in good condition you can check the voltage with a multimeter that is set to the car’s voltage range and connected to the terminals for minus and plus. If the voltage is lower than 12-13 volts, then you need to replace the battery. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start after this.
Faulty Receiver Module
If you don’t see the “Key Detected” message, it could mean that your receiver module is faulty. It’s that part that sends an alarm to the car when the key fob is activated it also acts as an immobiliser and prevents it from starting until the correct key is present.
This could be due to a variety of causes, such as water damage or simply aging. If the electronic chip in your Peugeot 308 keyfob is damaged by dirty tap water It could be because the keyfob was exposed to it. In this instance, you’ll need to take the unit apart and clean it thoroughly using isopropyl or electronic cleaner. Once the battery has dried you can attempt to test it again.
If the issue persists you’re probably in need of a idea to visit an area Peugeot specialist or locksmith. They will be able to make use of a diagnostic device to help pinpoint the issue and fix it.
It is stressful to lose your peugeot 107 key programming car key. However, a reputable auto locksmith can fix the issue in just a few minutes. They can program your car and cut a new, functioning key for you. Find locksmiths near you.
A malfunctioning electronic chip
The electronic chip in the Peugeot 407 Key Fob 308 key fob is a critical role in the remote control system. If the chip is damaged, you could have problems starting your car or receive a message stating “anti-theft”. In this case the only option is to replace the key. Luckily, auto locksmiths who are professionals can provide the service in the shortest amount of time.
The chip in your Peugeot 308 key fob can fail due to sweat, water damage, dirt or other reasons. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to cleanse it immediately. You can clean the electronic component with a paper towel soaked in isopropyl Alcohol. Then, you need to let the battery completely dry.
Sometimes keys can cease to function due to radio interference. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It could be caused by unsafe conditions or objects that are near to the vehicle. It is recommended to visit a Peugeot dealer if you experience this problem.
The peugeot 2008 key fob not working 207/308 key fob is extremely delicate and requires special attention. It should not be dropped or throw it around. If you lose something, try to locate it as soon as possible. You can reset all on-board computers by disconnecting the battery that is 12 volts for a short period of time. Unplug the negative cable prior to the positive.