Peugeot 308 Key Fob Replacement
peugeot 206 key fob replacement‘s 308 might be somewhat old-fashioned, but it is still striking. It might not be the most luxurious car in its class but the Ford Focus or Volkswagen Golf will protect you from surface imperfections – but it’s still a pleasant and a civilized drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent these tips will aid.
Water Damage
If you accidentally drop your key fob in the puddle, or it is wet while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry bag when you’re outside or performing things where the fob might be exposed to large amounts of water.
It is also important to ensure that the fob is completely dry before opening it up and re-using it. If you detect any odors from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it’s been submerged.
A wet circuit may cause the battery’s power to be depleted or even explode. If you’re able to pull your 308 key fob out of the water body it was stuck in it, flip the button side down and shake out as much water as possible before opening the case. When you’ve opened it, remove the battery and wipe down the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons your peugeot car keys replacements 308 remote keyless entry system could stop working include an empty coin battery or receiver module issues, signal interference, or an electronic chip that is damaged. If none of the above are the cause, you can try resetting your system by disconnecting the battery with 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system that allows the driver to start the car from afar, warming up or cooling down the vehicle prior to getting in. This feature is extremely beneficial, especially in the cold winter months. However, it is possible that the remote start system stops working due to a variety of reasons, such as the battery in the coin is dead.
The coin-shaped battery that is within the key fob may last between two and four years based on how often it’s used, the location it was purchased, and the way it is utilized. The date of use will be printed on the packaging or mentioned in the user’s manual.
If the key fob stopped functioning after exposure to water that is clean it is recommended to remove the battery, then clean the chip with a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If exposed to salty or soapy water, the chip may be fried and you will require replacing the key fob entirely.
If you are not sure the battery is in good condition you can check its voltage using a multimeter that is set to the car’s voltage range, and connect it to the plus and minus terminals. If the voltage is lower than 12-13 volts, you must replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should begin to run after this.
Faulty Receiver Module
If you don’t see “Key Detected”, it could be that your receiver module is not working properly. It is the part that transmits the signal when your key fob is activated. It also functions as an alarm and prevents the vehicle from starting without the correct key.
This could be due to a variety of factors including water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, for instance, the electronic chip on the inside will be damaged. In this situation, you’ll need to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once it’s dry you can put the battery back into the battery and try again.
If the problem persists it is a good idea that you visit the local Peugeot expert or locksmith. They’ll utilize a diagnostic tool to help pinpoint the issue and fix it.
It can be stressful to lose your Peugeot car key. A qualified auto locksmith can resolve the issue within minutes. They can program your car and cut a new functioning key for you. Click here to locate the nearest locksmith.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob is an important part of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message that says “anti-theft”. If this occurs, the only way to fix the issue is to purchase a new peugeot key fob key. Auto locksmiths with experience are able to offer the service in the shortest time.
The chip inside your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, you should cleanse it immediately. You can use a paper towel and isopropyl ethanol to clean the electronic component. The battery should then be allowed to completely dry.
Radio interference can cause a key fob to stop functioning. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. This can be caused by poor conditions or objects close to the vehicle. It is recommended to see a peugeot boxer key fob dealer if you encounter this problem.
The peugeot 208 key fob 207/308 Key Fob is fragile and requires special care. It is not recommended to drop it or throw it around. If you lose it, try to locate it as soon as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Be sure to disconnect the negative first, and then the positive.