Peugeot 308 Key Fob Replacement
Peugeot’s 308 may be slightly old, but it is still attractive. It’s not the most luxurious car in its class and a Ford Focus or Volkswagen Golf will isolate you even better from surface imperfections – but it’s still a pleasant and a civilized driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is ongoing or continuous these tips will aid.
Water Damage
If you accidentally drop your key fob into a puddle or it gets wet while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. The best way to prevent this from happening is to always keep it in a dry, dry bag when you’re out in the open or engaging in activities that require the fob to be exposed to a lot of water.
You’ll also need to ensure that the fob is dry prior to opening it and using it again. If you notice any odors emanating from the fob like an industrial liquid smell or that of windshield washer fluid, this is another indication that it’s submerged in water.
A wet circuit board can cause the battery to discharge its charge or even explode. If you’re able to pull your 308 key fob out of the water in which it was stuck in it, flip the button side down and shake it out as much water as you can before opening the case. Take the battery out, and then clean the circuit board using a cotton swab that has been dipped into 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system might be unable to function could be due to a dead battery for your coin or receiver module issue, signal interference, or an electronic chip that is damaged. If none of the above are the cause, you can reset the system by disconnecting a 12 volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system which allows the driver to start the car from afar, warming up or cooling down the car prior to entering. This feature is extremely useful, especially in the cold winter months. Remote start systems can not function due to a variety of reasons, including an inactive coin-battery.
A coin-shaped battery located inside the key fob has a lifespan of two to four years, depending on how often used and where it is purchased. The date of use is printed on the package or mentioned in the user’s manual.
If the key fob is no longer working after exposure to clean tapwater, remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then dry the chip completely before replacing. If the key fob has been exposed to salty or soapy water, it may have caused the chip to become damaged. You will need to replace it.
If you’re unsure if the battery is in good condition it is possible to test the voltage with an instrument set to the car’s voltage range, and connect it to the plus and minus terminals. If the voltage is lower than 12-13 volts then you need to replace the battery. You can also try to reset your on-board computer by disconnecting the battery at 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start.
Faulty Receiver Module
If you’re not seeing the “Key Detected” message on your dashboard, then it’s possible that the receiver module has developed a fault. It’s the part which sends out an alert when the key fob is activated. It also functions as an alarm that stops the car from starting without the correct key.
This could result from a variety of causes, such as water damage or simply ageing. If your Peugeot 308 key fob was exposed to dirty tap water, for instance, the electronic chip inside is damaged. In this case you will have to take it off and thoroughly clean it with isopropyl or an electronic cleaner. Once the battery is dry you can try it again.
If the issue persists then it’s a good idea to see an area peugeot 107 replacement key cost specialist or locksmith. They can utilize the diagnostic tool to pinpoint the problem and fix it.
It can be a stressful experience to lose your peugeot 2008 replacement key car key. A qualified auto locksmith can solve the problem within minutes. They can cut a brand new key and then program it into your vehicle, so you’re ready to get out on the road as fast as you can. Click here to locate a locksmith near you.
Faulty Electronic Chip
The electronic chip inside your Peugeot 308 key fob is a very important component of the remote control system. If it is damaged your car might not start, or you could receive a message saying “anti-theft active”. If this occurs, the only way to fix the problem is to obtain a new key. Fortunately, professional auto locksmiths can complete the task in the shortest time.
The chip in the chip of your Peugeot 308 key fob can be damaged due to sweat, water damage, dirt or other reasons. If your peugeot 2008 key fob key fob has been exposed to dirty or soapy water, it must be cleaned as soon as possible. You can wipe the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. Then, you need to allow the battery to completely dry.
Radio interference can cause a key fob to stop functioning. This could be caused by other devices operating on the same frequency as your Peugeot 108 Key key fob. It could be caused by poor conditions or objects close to the vehicle. If you have this issue it is advised to visit the peugeot 307 key dealership.
The Peugeot 207/308 key fob is extremely delicate and requires special attention. It should not be dropped or throw it around. If you lose something, try to locate it as soon as you are able to. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Be sure to disconnect the negative cable first, then the positive.