How to Replace the Replacement Key Battery For the Saab 9-3
saab 9-3 key replacement (learn more) owners must follow a set of special steps to install an additional ignition key. It requires dealer support using a handheld computer called Tech-2. Then it is necessary to purchase a new transponder. key have to be purchased.
Change your keys regularly to prevent one from deteriorating faster than the next. This will also help to keep your keys in top condition.
Replacement Case
The new key fobs aren’t like the old Saab keys. They have electronics which make it hard to copy. This has made car theft much more difficult than it was twenty years ago. It has also made it more expensive to replace lost saab key keys.
Saab 9-3 owners must have two keys that work. It is costly to replace a lost key because it requires replacing the CIM module, as well as reprogramming the locking cylinders. Dealers charge between $100-$200 for this.
There are some ways around these costly. Some parts retailers can look up the code from an extra key (usually the same one that opens the doors and switches the ignition) and cut a brand new metal key blade for only a fraction of the dealer’s cost. The key must be the exact same as the original for it to work in your vehicle.
Follow these steps to replace the case. You’ll need an open-faced screwdriver and patience. With the screwdriver you can pull off the plastic and then remove the emergency key. Once the case has been opened take out all electronic components and place them in the new case. Place the key with the correct badge inside the case.
Replacement Battery
The replacement battery for the saab 93 replacement key 9-3 is an affordable component that can be replaced easily and quickly. This video tutorial on DIY from YouTube Cyclone Cyd shows how to replace the battery in the remote key fob in only four steps. This tutorial is compatible with any modern Saab key fob. However, the process may differ slightly.
The button is normally located close to the Saab logo on the back of the fob. It’s usually just below the Saab logo on the back of the fob. Next use an screwdriver with a flat head to insert into the small hole inside this button. This will be enough to allow you to open the case of the fob so that you can replace the battery.
After you have installed the new CR1632 batteries, you can reassemble your remote key fob. You can then program it into your car. The entire process should not take more than an hour at most. It’s a very easy process that does not require any special tools.
If you lose a key, the process will be slightly more complicated, but it can still be done. The dealer must first read the VIN of the vehicle and then order an additional TWICE module and key blade with the correct unique code. The dealer will then have to program the key using MDI, a new software tool.
Replacement Key Fob
The key fob is a device that locks and unlocks your car. It has a battery within. The batteries last for a certain time, and they will eventually expire. This is a regular issue that happens with all cars and the good thing is that you can change the batteries in a majority of key fobs without replacing the entire case. You can buy fobs replacements on Amazon that come with all the electronic components already installed, so you can simply open the case and replace the batteries in the original case. It is necessary to remove the emergency key before you can replace the batteries. To do this, place a small flathead screwsdriver into the slot in the middle of the. The case will split once you work the screwdriver all around it.
If you’re ready to change your keys, make sure you have a spare in your possession. This will save you lots of money. If you have spare keys, you can request that the dealer cut a new key and program it to your car, which is cheaper than replacing the entire key fob.
If you don’t have a spare you can add an additional key to your car, however it requires a lot of research and effort. It can cost a few hundred dollars to purchase an additional car key. The computer of the vehicle must also be programmed. This can be accomplished by a professional, however it is an expensive option for the majority of owners.
Replacement Ignition
The current SAAB 9-3 uses an advanced alarm system built on a keycode. If you lose your primary key, it may be costly to replace it with another one since the car must have a specific computer installed and also be programmed to accept a brand new key. Even dealers can charge hundreds of dollars to program a new key even if they’re unable to complete the task.
If you’ve lost the only working key the dealer will replace the computer in your car (known as the CIM or saab key battery replacement TWICE) to create a replacement, and they will charge you the highest price for it. We can reprogram the EEPROM on your car’s computer to make it prepared for a new key. This will save you more than 50% off the cost you would pay a dealer.
If you’ve been a long-time owner of an 03-11 saab spare key 9-3, then you probably have noticed that the ignition switch isn’t really all that robust. They can get extremely sticky and the buttons are known to be removed from them from time to time which is why you should think about getting a replacement if yours isn’t working properly. Luckily, replacing the ignition key isn’t as complicated as it seems, and it can be done in a short time with the proper tools.