How to Replace a Nissan Juke Spare Key
Nissan Juke is an attractive and fun hatchback that features a unique engine configuration. It’s noisy, but it’s still a lot of fun to drive.
Replace the battery in the key fob of your Nissan Juke every two years, or when it is low. You can do it yourself, however you will need some tools.
Dead Coin Battery
If the key fob in your nissan key programmer Juke is not working, check the coin battery. It may be dead and requires to be replaced. This is a simple fix that only takes a few moments. It’s as easy as flipping the fob upside down and removing the tiny latch/release located on the back. Replace the battery you have previously installed by making sure it’s facing the bottom of the fob. Place the two halves carefully.
If the fob has been exposed to water, it needs to be cleaned before putting the new battery into. This can be accomplished using a paper towel and isopropyl alcohol or electronic cleaner, and waiting for it to dry completely before inserting the battery.
The key fob needs to be connected to the car to start it. This can be done by following the directions in the owners manual or an OBDII scanner. The most likely reason why the key fob stopped working is because it wasn’t properly paired. It is also possible that the fob has an issue with the chip, but this is rare. In this instance the need for a new receiver module could be required. If this is the scenario, the module will need to be replaced by a certified technician.
Water Damage
Key fobs operate on batteries and the batteries need to be replaced every two years or when the car ceases to respond when you push the “start” switch. Keys come with rubber seals that keep water out, but submerging your key fob in a pool or ocean water could cause damage to the chip that is inside. If this is the case, you will need to obtain a new key from Nissan or an automotive locksmith.
It’s possible that the computer has lost connection with the key fob and this could be caused by a variety of factors. A simple restart of your car will fix this issue, but if the key is still showing the “Key ID” error message, you’ll need to contact Nissan or an auto locksmith to get help.
The three most common causes of this issue are dead battery on the key fob and keys that are not programmed and a damaged, or malfunctioning key fob that has been damaged or broken. The first two are fairly simple to fix while the third is more difficult to diagnose and repair, but can be resolved with patience. WhoCanFixMyCar allows you to compare Nissan Key Replacement prices in your area and schedule your repair. You can read about the experiences of local nissan key programming software dealerships, nissan armada key replacement mechanics, and garages in a matter of moments.
Faulty Chip
The key fob of your Nissan Key Fob Programming Juke has a special chip that sends a signal to the car when you turn it. The key can be inoperable when the chip is defective. In this instance it is only possible to solve the issue by replacing the key. There are several reasons why your Nissan Juke’s keys could be defective, such as water damage or a dead coin battery or a malfunctioning receiver module.
If your key fob stopped working after a soak in the wash or bath, it is important to examine the chip for water damage. Check that the metal retainers on the chip are secure. Also, ensure that the chip isn’t surrounded by water. If you see any indications of water damage on the electronic component, remove the battery and wipe it down with isopropyl ethanol or electronic cleaner.
If the chip is damaged You will need to visit your local locksmith or dealership. They will need the year as well as the model, make and year of your vehicle in order to locate an appropriate replacement. It is also necessary to write down your VIN (Vehicle ID Number) to ensure that the dealer or locksmith knows the key you have. This will allow them to find the correct key code and make sure that they cut the correct key.
Faulty Receiver Module
The key fob sends a radio signal to your car to perform various functions. It can open the trunk as you rush to get groceries or start your car by pressing the button on the fob. It can even open your windows and switch on the horn should you accidentally lock your keys inside the car.
If the key fob ceases working, it could be problems with the receiver module in the vehicle. The receiver modules are tuned to ensure they can detect specific frequencies that correspond to signals sent by Nissan key fobs. If your car has a faulty receiver module and it stops responding to any signal received from the key fob.
No matter how your nissan figaro key key fob ends up getting damaged, it’s always recommended to have a spare in case the key gets broken or lost. A locksmith or dealer can program a spare key that works with your Nissan. This will save you from the hassle of losing your keys or locking them in your car.
If your Nissan Juke’s key fob has been exposed to rain or clean tap water, you can resolve the issue by cleaning it using isopropyl or an electronic cleaner. If the chip has deteriorated, you will have to buy a new key fob, which can be coded to your car by a locksmith or a dealer.