peugeot expert key 308 Key Fob Replacement

Peugeot’s 308 might be catching on a bit, but it still feels appealing. It’s not the most luxurious vehicle in its class, but it’s an enjoyable and relaxing driving experience.

Here at Coded Car Keys we are often asked to replace peugeot key fob reprogramming 308 key fobs. The following tips will assist whether the issue is constant or intermittent.

Water Damage

If you leave your key fob in a pool or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it’s likely to be damaged by water. Keep your key fob in a dry bag every time you are outdoors or engage in things that expose it to excessive amounts water.

It’s also essential to make sure the fob has completely dried out prior to opening the fob and then use it. If you notice any odors coming from the fob, like an industrial liquid smell or that of windshield washer fluid, this is another sign that it’s submerged in water.

A wet circuit can cause the battery’s charge to be drained or even explode. If you are able to get your keyfob 308 out of the water you need to turn the button side up and shake as much water as you can before opening the casing. Remove the battery, then clean the circuit board using a cotton swab that has been submerged in 90 percent alcohol.

Other reasons why your Peugeot 308 remote keyless entry system may be unable to function could be due to the battery of your coin is dead or receiver module issues, signal interference, or an electronic chip that is damaged. If none of the above is the cause it is possible to reset the system by removing the 12 volt battery from your car for 15 mins.

Dead Coin Battery

Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from afar while warming up or cooling down the car prior to entering. This feature is extremely beneficial especially during the cold winter months. Remote start systems can cease to function for a variety reasons, such as the battery being dead.

A coin-shaped battery found inside the key fob has a lifespan of two to four years, depending on how frequently it is used and where it’s purchased. Its use-by date is typically found on the packaging or written in the manual.

If the key fob stopped working after exposure to clean tapwater, take out the battery and clean the electronic chip using a paper towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob was exposed to soapy or salty water, it may have caused the chip to be damaged. You’ll need to replace it.

If you’re unsure whether the battery is damaged it is possible to check its voltage using a multimeter that is connected to both the terminals for plus and minus. The voltage should range from 12 to 13 volts, but if it’s lower, the battery should be replaced. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now start.

Faulty Receiver Module

If you don’t see the “Key Detected” It could be the receiver module defective. It’s the component which sends out the signal when your key fob goes off. It also acts as an alarm, and stops the car from starting without the correct key.

The cause could be many causes, such as water damage or just ageing. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip on the inside will be damaged. In this case you’ll need to remove it apart and clean it thoroughly using isopropyl alcohol or electronic cleaner. Once the battery has dried, you can try again.

If the issue persists, it is recommended to see the local Peugeot expert or locksmith. They’ll make use of a diagnostic device to assist in identifying the problem and repair it for you.

Losing your Peugeot keys to your car is an emotional experience. A certified auto locksmith can solve the issue in minutes. They can cut a new key and programme it to your vehicle, ensuring you’re back on the road again in the shortest time possible. Click here to find a locksmith near you.

Faulty Electronic Chip

The electronic chip that is in your peugeot 308 key fob (kaplan-Field-2.blogbright.net) is an crucial component of the remote control system. If it becomes damaged, your car may not start or you might receive a message saying “anti-theft active”. In this situation the only option is to replace the key. Luckily, professional auto locksmiths are able to provide this service in the shortest amount of time.

The chip in your peugeot 206 key fob replacement 308 key fob can be damaged by sweat, water damage dirt, or any other cause. If your peugeot 107 key fob not working 308 key fob (kaplan-Field-2.blogbright.net) has been exposed to soapy water, clean it immediately. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. Then, you need to allow the battery to dry completely.

Sometimes keys may be inoperable due to radio interference. This could be due to other devices use the same frequency as your Peugeot keyfob. It could also be caused by bad weather or objects around the vehicle. It is recommended to see a Peugeot dealer if you have this issue.

The Peugeot 207/308 key fob is very delicate and requires care. It is not recommended to drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset your on-board computer by disconnection of the battery for a few minutes. Be sure to disconnect the negative cable first, then the positive.

Leave your comment